Recent content by 68steiny

Re: LSX Swap Mounts and Oil Pan I have a modded H3 pan that I will be selling, it has the turbo return bung and no need for oil filter, but you will have to do your own mounts.

Re: LSX Swap Mounts and Oil Pan That is the way I am going. You will need to do a remote mount oil filter and weld in a bung for oil return if you go turbo.

Re: LSX Swap Mounts and Oil Pan I am doing the swap right now. I started out with the modded H3 pan and the Dirty Dingo mounts. Note that the DD mounts sit the engine up pretty high and I had to modify the trans tunnel. The RPM stuff on the other hand sits the engine really low and you need...

Re: New Belltech Leaf Springs Re: New Belltech Leaf Springs Cool, I'll take them. You wanna PM me you payment stuff, please.

Re: New Belltech Leaf Springs Re: New Belltech Leaf Springs Can you give me an estimate of cost to ship to Chicago? Thanks.

Re: LSx SyTy Swap Information I'm doing a 60e, if you want that pinion angle correct, it needs a bit of mod.

Re: LSx SyTy Swap Information Trans tunnel modification should also be added to this list, I was actually surprised at how much a couple inches of lifting the trans/transfer case dug into the tunnel.

Re: L33 swap There is a lsx swap thread over at one of the s10 forums and they go in depth on what fits as far as exhaust...good luck.

Re: L33 swap The engine is going to sit a little higher than the 4.3 and therefore you will need to bend back that trans/firewall lip and a spot back in the trans tunnel where the transfer case touches the tunnel.

Re: L33 swap Subscribed, very cool.

Re: Distributor with Hall Effect trigger I just did this with a Motec ecu and a dual sync. If you have a MSD box, you need to set on a rising trigger for the ignition, MSD only sees rising trigger. You will find the trigger set somewhere between 0 and 50 once you do that. I pulled all the...

Re: Wiring Harness Question(s) Thanks very much...this will let me do a little more research and see if I can use it. I am not sure of familiarity between the 165 and the 411 but I will be checking to see if there is an AC request and clutch control. I still have the AC wires available on the...

Re: Wiring Harness Question(s) Dave, do you mind briefly describing the AC setup or do you possibly have a link on syty. I am rewiring the existing harness for a 411 pcm and am going to keep the stock AC setup, but some of the wires are cut. There are 2 connectors for the AC harness portion...

Re: h3 alpha oil pan Here are some photos of my mock up with the H3 oil pan and Dirty Dingo mounts. I'm also going to attempt to modify a set up ZL1 exhaust manifolds. So far everything "APPEARS" to fit like a glove. I bought the pan from XplicitRacing and really happy with it, fits...

Re: speedometer I built an existing 5.3 truck harness and am also quite confused by the VSS signal, so I won't be permanently wiring it in until it works. I am doing a 5.3/4l60e combo and the 4l60e has a VSS signal on it also...that is why I am waiting. According to the Sy diagrams the VSS...