Recent content by Quickstop [UK]

Re: Decelaration Surging So the issue didn't exist before the gauge install? Can you disconnect it to see if that cures the problem then work it out from there?

Re: Daughters First Ty??? Until she has done a tranny pull, engine pull, motor mount swap, distributor change, compression test, setting timing and valve lash, half shaft pull, prop shaft R&R, coilover install, ball joints and tie rods, Putman arm swap, she should hold off until she can make an...

cIvCRFSlbow Today. You're welcome! :cool: (So, so happy it's finally performing!)

Re: Idle/drive transition and bogging with the TC locked Thanks guys - appreciate the input. I have a slightly more updated tune now and the truck drives a lot better. The bucking from the TC has gone and now the truck pulls like a freight train with the TC locked in 4th gear. At around 5-7...

Re: RHD Saudi Syclone in Australia I'm sure I'll be corrected but I thought there weren't any. There may have been 4 but pretty sure it's a typo. The bit that I just discovered was that a LHD car in Aus is illegal so I now need to figure out what the hell to do with mine. Look at the prices...

Re: RHD Saudi Syclone in Australia 1992 GMC Syclone TURBO AWD Ute | Cars, Vans & Utes | Gumtree Australia Gold Coast City - Bundall | 1142067623

Re: Turbo advice That was a PTE housing that RPM had. They did the 3" dp and fed the wastegate back into the exhaust.

Re: Turbo advise Re: Turbo advise Thanks mate, very kind of you! Here is a pic I took when I was building it all... DSC00166.jpg Photo by UKTyphoon | Photobucket

Re: Idle/drive transition and bogging with the TC locked No progress to report - maybe someone can help? What XDF and ADX file do I need for a Code58 .bin in TP5? I can log the ALDL but I can't get the tracing bubble so I can't work out which cell to adjust and tune the truck. Is it possible...

I'm finally driving my truck after 4 years off the road and it's awesome but it could be a lot better. I'm getting a lot of help with Code59 but for now I have a pretty good Code58 tune that is working well though I have a couple of issues and figured I may as well ask here so maybe someone...

Re: Turbo advise Re: Turbo advise I have that turbo and it is excellent. I have an external WG controlled by a Greddy Profec B2 system. I need to dial it in. The WG is a Tial 42 mm I think. The exhaust vents back into the DP. You may need a spacer for the stock manifolds and also to grind a...

Re: Transmission rebuild ( hard parts ) Hey man, don't apologise for a silly question. It's better to look foolish for a moment than be foolish forever. Always happy to help if I can. Fcuk those douchebags that belittle those who need help. Git r dun mate.

Re: Transmission rebuild ( hard parts ) Hey man, don't apologise for a silly question. It's better to look foolish for a moment than be foolish forever. Always happy to help if I can. Fcuk those douchebags that belittle those who need help. Git r dun mate.

Re: Transmission rebuild ( hard parts ) Your photos are all upside down. You are indeed missing the selector cable bracket. It goes next to the shift lever. It's long and narrow with a fixture to hold the cable. I don't think that suspension mount is a spacer. It's so you can bolt up a...

Re: Rear bracket for CS144 alternator I was wanting to know if the drilling that you do causes misalignment with the stock alt should you swap back.