How do you guys route the wideband o2 wire harness from the engine bay and into the cabin? Is there a specific place on the firewall to pass the harness through?
After tightening the ground I haven't had any issues. It was tight but I tightened it even more and I drove it around for over 8 hours and not a glitch. Thanks for all your input everyone.
I am located in Miami FL.
There was no corrosion on the terminals and none of the wires are shown to be frayed or worn.
I retightened the reacetronix ground terminal and drove it around a bit and so far all is good. If it does it again I will bypass the Racetronix harness and see if that...
I have an issue with my truck that just started after upgrading to get ready for a 20 G turbo install. Prior to this the truck has never been mucked with. No mods whatsoever, 1 owner vehicle. Last week I upgraded the fuel pump to a Racetronix 255lph with Racetronix wire harness, 60 lbs...