SchnellGhostTy
New member
ALL SOLD
Here it is!
Almost new, everything has less then 2500 miles on it! Every Sensor and Bolt Was Replaced!
I snapped the crankshaft and have decided to put an LS in it instead of rebuilding a 4.3 again so everything 4.3L related must go.
I want to try and sell in groups of particular systems per say since things are engineered specifically around the parts assembled.
The rotating assembly still needs to be inspected as of 1/1/14
*JE Forged Aluminum Pistons 8.5:1 $
*Eagle H Beam Forged Rods $
*Stock Typhoon Engine Block .030 Over 2 Bolt Mains
ARP Head Studs and Bolt Mains $
*Comp 412 Camshaft $
*Deepened Oil Pan and Welded AN Oil return Line Fitting $SOLD
TURBO KIT
*GTX3582R Garrett Dual Ball Bearing Turbo W/ Billet turbine Wheel
(It whistles like a supercharger at idle) $
*Full Boost at 2500RPM
*AN Lines - Coolant Feed and Return and Oil Return - stock oil feedline $
*T3 Turbo Manifold Spacer w/ external 38MM Wastegate $
*Tial 38mm Wastegate Blue $
*Custom Stainless Steel Dump in front of the Passenger Well $
*4" Intake 90* with PCV System AN Connection $
*AFE Cone Filter $
*Custom Aluminum Turbo to Intercooler Pipe with Tial 40MM Blow Off Valve & Wastegate Boost Pressure AN Fitting $
*3" Down Pipe, 2 Vband Clamps and a sleeve at the end to match the rest of the exhaust $
*PCV System - AN lines to Moroso Oil Separator and then to intake w/ 3 factory check valves, two on pass and one on driver side $
*Complete Vacuum line setup(As its supposed to be! in complete AN Fittings and un-collapsible Silicone Lines! + BOV Line and Gas Canister Recirc/Delete lines not shown) $
^^^$ for everything as a kit^^^
*Stock Exhaust Manifolds w cross over $
INTERCOOLER KIT
*Polished ATR/Conely HUGE Water to Air Intercooler W/ Custom Fill Cap $SOLD
*ATR Upper/Lower w/ dual 4 Electric Fans and Radiator Mount Heat Exchangers $
*Mezier High Flow Billet Cooler Pump 20 gallons per min! $
*AN High Temp Hoses and AN Fittings on it all! $300 worth of lines alone
^^^$ as a complete kit w/o upper intercooler^^^
OTHER POLISHED GOODIES
*Polished Edlebrock Valve Covers $
*Polished Upper Intake Plenum w/ Hardware, IAT Sensor & EGR Delete
*Stock Painted Black Lower Intake Manifold + 12* Hardware $
*Polished RPM 58MM Throttle Body With TPS and I Sensor $
*BNIB Polish Edlebrock Waterpump - $SOLD
*Polished RPM A/C Delete Kit Comes with their belt and the one that I used Hardware and all $
http://i133.photobucket.com/albums/q53/SchnellMotorsports/For Sale/IMG_2111_zps523c742a.jpg
TUNING - AIR/FUEL
Moates Osteritch 2.0, Moates Emulator, ECU w/ All Cables plus IBM Laptop $
Code59 Software and TunerProRT
PLX Wideband 02 Sensor, Omari Tru Color Boost and EGT Gauges $
MSD 6AL Box 5500RPM Plug & Plug and Play Harness + MSD Master Blaster Coil $SOLD
Accel Distributor $
Accel Ceramic 90* Wires w/ heat boots $
RPM Adjustable Fuel Pressure Regulator $
RPM Matched 50lb Injectors $
3 Bar Map $
^^^$ as a kit^^^
OTHERS
*4L60E Transmission, Built(Not sure how, have receipt from previous owner, about 20K on it and smooth shifts, hard launch doesn't use any fluid nor burn it, its as it should be! $
*High Output Black Alternator $
*Optima Red Top Battery $
*Meth Injection with Controller and Pump $
*I might sell the interior which is basically mint, minimal wear on the front seats
Thanks,
Alex
(303) 726-1095
Here it is!
Almost new, everything has less then 2500 miles on it! Every Sensor and Bolt Was Replaced!
I snapped the crankshaft and have decided to put an LS in it instead of rebuilding a 4.3 again so everything 4.3L related must go.
I want to try and sell in groups of particular systems per say since things are engineered specifically around the parts assembled.
The rotating assembly still needs to be inspected as of 1/1/14
*JE Forged Aluminum Pistons 8.5:1 $
*Eagle H Beam Forged Rods $
*Stock Typhoon Engine Block .030 Over 2 Bolt Mains
ARP Head Studs and Bolt Mains $
*Comp 412 Camshaft $
*Deepened Oil Pan and Welded AN Oil return Line Fitting $SOLD
TURBO KIT
*GTX3582R Garrett Dual Ball Bearing Turbo W/ Billet turbine Wheel
(It whistles like a supercharger at idle) $
*Full Boost at 2500RPM
*AN Lines - Coolant Feed and Return and Oil Return - stock oil feedline $
*T3 Turbo Manifold Spacer w/ external 38MM Wastegate $
*Tial 38mm Wastegate Blue $
*Custom Stainless Steel Dump in front of the Passenger Well $
*4" Intake 90* with PCV System AN Connection $
*AFE Cone Filter $
*Custom Aluminum Turbo to Intercooler Pipe with Tial 40MM Blow Off Valve & Wastegate Boost Pressure AN Fitting $
*3" Down Pipe, 2 Vband Clamps and a sleeve at the end to match the rest of the exhaust $
*PCV System - AN lines to Moroso Oil Separator and then to intake w/ 3 factory check valves, two on pass and one on driver side $
*Complete Vacuum line setup(As its supposed to be! in complete AN Fittings and un-collapsible Silicone Lines! + BOV Line and Gas Canister Recirc/Delete lines not shown) $
^^^$ for everything as a kit^^^
*Stock Exhaust Manifolds w cross over $
INTERCOOLER KIT
*Polished ATR/Conely HUGE Water to Air Intercooler W/ Custom Fill Cap $SOLD
*ATR Upper/Lower w/ dual 4 Electric Fans and Radiator Mount Heat Exchangers $
*Mezier High Flow Billet Cooler Pump 20 gallons per min! $
*AN High Temp Hoses and AN Fittings on it all! $300 worth of lines alone
^^^$ as a complete kit w/o upper intercooler^^^
OTHER POLISHED GOODIES
*Polished Edlebrock Valve Covers $
*Polished Upper Intake Plenum w/ Hardware, IAT Sensor & EGR Delete
*Stock Painted Black Lower Intake Manifold + 12* Hardware $
*Polished RPM 58MM Throttle Body With TPS and I Sensor $
*BNIB Polish Edlebrock Waterpump - $SOLD
*Polished RPM A/C Delete Kit Comes with their belt and the one that I used Hardware and all $
http://i133.photobucket.com/albums/q53/SchnellMotorsports/For Sale/IMG_2111_zps523c742a.jpg
TUNING - AIR/FUEL
Moates Osteritch 2.0, Moates Emulator, ECU w/ All Cables plus IBM Laptop $
Code59 Software and TunerProRT
PLX Wideband 02 Sensor, Omari Tru Color Boost and EGT Gauges $
MSD 6AL Box 5500RPM Plug & Plug and Play Harness + MSD Master Blaster Coil $SOLD
Accel Distributor $
Accel Ceramic 90* Wires w/ heat boots $
RPM Adjustable Fuel Pressure Regulator $
RPM Matched 50lb Injectors $
3 Bar Map $
^^^$ as a kit^^^
OTHERS
*4L60E Transmission, Built(Not sure how, have receipt from previous owner, about 20K on it and smooth shifts, hard launch doesn't use any fluid nor burn it, its as it should be! $
*High Output Black Alternator $
*Optima Red Top Battery $
*Meth Injection with Controller and Pump $
*I might sell the interior which is basically mint, minimal wear on the front seats
Thanks,
Alex
(303) 726-1095
Last edited:
