AWDcameoLSX
Member
Output shaft for 4L80E, to mate up with the stock transfer case. Designed by Jeff Scott, initally purchased via TurboTime. Will work with the transfer case adapter sold by SyTyPerformance. Was originally a $500 adapter. $250 shipped. It is a 4L80E output shaft that has 27 splines to fit the stock transfer case. SOLD
I also have a TE45 turbo. No nicks on the fan blades anywhere or any major defects. The bearing has no forward/aft shaft play but minimal side play (sorry about my type-o from before). As to answer the most common question. It is very close specs to a pte63. It has a T04BP turbine wheel and a 63mm compressor wheel but uses the large type bearing(should spool up a lil quicker). Buick guys say its good for around 650hp. $425 shipped. PM me if you have any questions. SOLD
Pics now up:
I also have a TE45 turbo. No nicks on the fan blades anywhere or any major defects. The bearing has no forward/aft shaft play but minimal side play (sorry about my type-o from before). As to answer the most common question. It is very close specs to a pte63. It has a T04BP turbine wheel and a 63mm compressor wheel but uses the large type bearing(should spool up a lil quicker). Buick guys say its good for around 650hp. $425 shipped. PM me if you have any questions. SOLD
Pics now up:
Last edited:
