intake?
- Thread starter Bewbzout
- Start date
SY756
New member
Re: intake?
If you're talking about the intake manifold or the plentum, most everyone on here uses factory stuff. Unless you have fabrication skills or $$$$$ you're pretty much limited to stock ones. Now, if you're talking about a cold air intake then that's a different story. I know that Kenne Bell and ATR used to make them but I haven't dealt with either of them in years. Someone else on here would know for sure. But you could probably find one used somewhere. Either that or fabricate something up on your own.
If you're talking about the intake manifold or the plentum, most everyone on here uses factory stuff. Unless you have fabrication skills or $$$$$ you're pretty much limited to stock ones. Now, if you're talking about a cold air intake then that's a different story. I know that Kenne Bell and ATR used to make them but I haven't dealt with either of them in years. Someone else on here would know for sure. But you could probably find one used somewhere. Either that or fabricate something up on your own.