New engine going in........

0260IN3

0260IN3

Engine Builder
well it's time. The new bullit is going in this weekend. It's a long weekend for us so hopefully i can get the old motor pulled and the new one sitting in the truck by monday. Got lots to do when the engine is out, but luckily it's not my first.

With any luck it will be running next weekend, and can get some street tuning done..............then put it on the chassis dyno and see how much these tank drive trains take away for power.

Never the less.............750 ft.lbs will be fun on the street!!
 
1BADSUV

1BADSUV

New member
Re: New engine going in........

I have been reading your progress on that motor and the impressive numbers it put down on the engine dynometer, cant wait to see what the awhp will be.:) Might be interested in one of your budget build-ups for my 92' Typhoon.
 
SEL777

SEL777

One of 101
Re: New engine going in........

I'm anxious to see what it'll do in the truck. I followed the other thread about that budjet build too. How's the TT Tahoe project coming along? I say tow the Ty down to the NATS with the TT Tahoe. I'll see you there....I'll be one of the ones DROOLING over both.
 
0260IN3

0260IN3

Engine Builder
Re: New engine going in........

SEL777 said:
I'm anxious to see what it'll do in the truck. I followed the other thread about that budjet build too. How's the TT Tahoe project coming along? I say tow the Ty down to the NATS with the TT Tahoe. I'll see you there....I'll be one of the ones DROOLING over both.
Click to expand...

I going to try and come to the nats but my wife is due with our first child around then so????????????????
 
0260IN3

0260IN3

Engine Builder
Re: New engine going in........

12secondSY said:
Did you ever get the dyno numbers at the wheels on this?
Click to expand...

Need to finish the chassis dyno stuff another time but intial number show about a little less than 30% loss to the wheels. The truck is making 440 at the wheels, but ran out of time on the day I was dyno testing. I am a couple degrees of timing short from where we were on the engine dyno so should be able to see 450-460 at the wheels when all done.

Some datamaster runs show 11.9's at 114 mph at 18-19 psi. I have yet to make a run a 25 psi.....................but holy shit..................there is a big difference when it gets into the 24-25 psi range.

Should run mid 11's no problem...................a coulpe weeks and the track will be open to test.
 
You must log in or register to reply here.
Top