Syclone #411 Dyno Vid

[h0twh3els]

Here's a quick vid of my truck on a Dyno Dynamics AWD dyno.

Trucks running 19 PSI with the RPM Stage 2 turbo. I ran out of compressor.

@ 2600 RPMS the truck made a tad bit over 300 horse and 480 ftlbs of torque. I've never seen a curve on a dyno as linear as this one.

http://youtu.be/Me44jKhTnE4

 

[randy merritt]

Re: Syclone #411 Dyno Vid

please post a pic of your dyno chart. I would like to compare it to the one I generated on a mustang AWD dyno. Mine was anything but linear.

 

[h0twh3els]

Re: Syclone #411 Dyno Vid

Yeah, I'll post one up tomorrow. The truck had to be fine tweaked on the street so I pick it up tomorrow. My curve was flat and then tapered off due to crappy flowing L35 heads!!!!

 

[randy merritt]

Re: Syclone #411 Dyno Vid

Do you have the rpm vs hp, or mph vs hp, or both? Both charts would be nice if you have them.

 

[h0twh3els]

Re: Syclone #411 Dyno Vid

Do you have the rpm vs hp, or mph vs hp, or both? Both charts would be nice if you have them.

I'll get them both tomorrow.

 

[jpalmer]

Re: Syclone #411 Dyno Vid

remember, Alex made pretty big power on ported l-35's, you are not requiring the heads to suck their own air, it is pushed in, making "flow" not "as" necessary. Where is your timing at, and what fuel you running?

 

[h0twh3els]

Re: Syclone #411 Dyno Vid

remember, Alex made pretty big power on ported l-35's, you are not requiring the heads to suck their own air, it is pushed in, making "flow" not "as" necessary. Where is your timing at, and what fuel you running?

19 degrees advanced

93 + Methanol

The truck is making the power RPM says it should with their turbo upgrade. Next up is the ported brodie heads and a 67mm turbo.