Turbotime Rear Coilover Preload

[dgoodhue]

I am installing my turbotime rear shock/coilovers on my Syclone. How much of prelaod has everyone used. I am just trying to get an idea to get me start in the right direction. I have Belltech lowering springs as well.

 

[Daryl H]

Re: Turbotime Rear Coilover Preload

I am installing my turbotime rear shock/coilovers on my Syclone. How much of prelaod has everyone used. I am just trying to get an idea to get me start in the right direction. I have Belltech lowering springs as well.

Put the truck on the ground and pre-load them to where the truck stance looks good.

Drive around and check again. Done.

 

[dgoodhue]

Re: Turbotime Rear Coilover Preload

Put the truck on the ground and pre-load them to where the truck stance looks good.

Drive around and check again. Done.

Its kind of hard to do that without an engine in the truck

 

[hatrik8]

Re: Turbotime Rear Coilover Preload

Its kind of hard to do that without an engine in the truck

:rotf: Classic sy response.

 

[E-Rue]

Re: Turbotime Rear Coilover Preload

you need to start by putting just enough preload for the spring to fit tight with the suspension at full droop. start there and increase it as needed to get the ride your looking for. you probably wont adjust it much from there if at all.

e