Recent content by Curless Auto

Re: Finally doing something with mine... So, I decided to get into one of Holley's training seminars on their EFI. I closed my shop last week and took both of my employees to Bowling Green to Holley's headquarters and went through tier one training. I would like to give a big shout out to...

Re: Coil over conversion Only thing we see is that we now need to lower the rear about 2 inches. Just got the call, headed to pick it up from the alignment shop in a few minutes.

We just installed a coil over conversion from Sport Machines on a customer's Phoon, very nice components! Dropped it off for an alignment this morning, I must say that wishy washy, lift and dive suspension feel is completely gone. Very nice, can't wait to drive it when its aligned! Thanks to Tom...

Re: Finally doing something with mine... So got ahold of Holley... the menu is is in the "help" tab on the disc... I guess that's great but wouldn't you think that there would be an install tab? I always assume that the help tab sends you to an online answer center or email... Guess I should...

Re: Finally doing something with mine... Tried to read up on it this weekend, can't navigate the disc that came with it at all. Its only tuning... no instal instructions to be found...now to try to get someone at Holley to help see if I got a bad disc or what...so far.... not impressed at all...

Re: Finally doing something with mine... You are exactly right! I bought a refurbished computer from a high end local company and one piece of software was not compatible with Holley's. Simple download fixed that. Now on to the instructions. Hope to actually start the instal next week. Gives...

Re: Finally doing something with mine... SO me and technology do not get along...bought a new laptop for data logging and tuning...bought the Holley set up...dropped the disk into the laptop... can't get through the installing of the software so I can read anything... now to try to get through...

I posted a while back that I bought decently built (back in the late 90's) Phoon and it has not run since 03... it had an accel 1st gen DFi in it...requires a dos computer to tune:tdown:... so its been sitting for years. Ordered a Holley Dominator set up for it yesterday and it here today! SO I...

Re: Feel like I won the lottery Thanks guys, I don't take anything personal at all. Gotta have a thick skin to hang out with my friends! Not really sure what I want to do with this thing. Its got so much stuff done to it, does not run currently...old school electronics, not sure I want to...

Re: Feel like I won the lottery When we made the purchase agreement it included all pieces and parts laying around...I knew about the rims, and the block but the other stuff was found in the midst of a bunch of vette parts. I did offer her something for the stuff she had found but she refused...

So today, I dropped by the house of the widow I bought my Ty from...she told me there were a bunch of parts found in the garage...Factory GM manuals, original radio, intercooler, exhaust, heads, block, extra headers, spare tire assembly, wheels with centers, turbo, rods, T-case, front diff...

Re: just bought sy 1357 for $1500 Good score! Rip the trans out and get her fixed up!

Not many of you know us but we are Curless Auto Repair of Grand Rapids Michigan. A small local shop that specializes in restorations and custom vehicles. We have quite a following of early (C1 - C2 - C3) Vettes, Marauders (03-04), and muscle cars...since logging on a few weeks ago we have had a...

Re: Who Makes Safety Loops For Prop Shaft? If you guys can get me a sample photo or actually let me see one I can have it recreated easily.... Not trying to circumvent anyone else' interest here just making an offer to help out.

Re: Newb from Michigan Howdy from GR!