Search results

We moved across the mountains, more dry day to drive. I haven't heard of any syty around so if anybody is close by let me know or if anyone is crossing the pass look me up:cool:

Sat March, 20 at Lynnwood Hooters at 2 o'clock, Everybody's welcome. http://www.nwstp.com/forum/topic.asp?TOPIC_ID=192

Somewhere I saw a fix on hood shake, anybody remember where it was or have a fix. Yes I searched

When I tried to use my old avatar it said the size was to large do I need to find a new avatar

How many 92 Syclones were made, How can I tell if it's really a 92 and not just a 91 sold in 1992 :roll:

How many 92 Syclones were made, How can I tell if it's really a 92 and not just a 91 sold in 1992 :roll:

What is the easist way to loosen the dist. , or that works best :roll:

Does anyone have a picture of where the bar attaches to the frame rails on a Sy. I looks like one side goes through the rear fuel tank bracket and the other side is almost in the frame jig hole. :shocked!:

On the lower front side of the throttle body there is a 1/2 inch open (looks like a hose fitting) nipple is this suppose to be open or capped, what is it for.

I just installed a FPR (rpm) and the fuel press gauge bounces over about a 10 lb range the stock one was steady is this normal.

Is the plastic deflector behind the CAC under the front of the truck still available, if not is it necessary for cooling or anything else :roll:

Since the mufflers have holes in them, its time to replace them what's the best exhaust system from the cat back. the truck is stock. :o

Someone told me that I am losing bost at WOT. from looking at my Datamaster file. What would cause that ??????? :shocked!:

Just got my datermaster hooked up and did a couple of runs is there anybody that could take a look and see if everthing looks ok. I'm putting in a ultimate chip, 3-bar and fp reg. and wanted to make sure I don't have any problems before I put them in. thanks :o

Could someone take a look at a datamaster file for me this is my first log of my sy and I not sure what i'm looking at. Thanks wally

Instructions say that the 3-bar programs are tuned for a stactic fuel pressure of ~50 psi at idle. What do I need, less than 50 psi or 50 psi, I believe stock sy's have 45 psi :o

The oil pump went out and took thr crank with it on my 1999 blazer it has a 4.3 w motor in it . I'm going to put a new motor in it, is there any parts that will fit my sy like the heads or anything else :roll:

someone had a picture of a license plate frame on a sy that said "this is the truck your mother warned you about" on it . Did you have this frame made or do you know where I could get one. :roll:

What is the best all around chip for a Syclone mostly stock and where can I get one. Thanks